Engine Panel Pinouts

2123VC
Backlight (5V) T / U
ENG1 FIRE LT R / P(GND)
ENG2 FIRE LT W / V(GND)
ENG1 FAULT LT R / K (GND)
ENG1 MASTER SWITCH H/N
IGN START A / M
IGN NORM D / M
CRANK G / M

2122VC
ENG2 FAULT LT F / M(GND)
ENG2 MASTER SWITCH L / D

Reference
AWM 73-25-01; 73-25-09; 73-25-11; 73-25-12; 26-12-01; 26-12-02

eng-pinouts

Pinouts diagram remains the property of Simon Stusek. Not for commercial use, or publication without permission.

pin-out_115vu

3 thoughts on “Engine Panel Pinouts

    • Hi Soumen,

      If the joystick board solution suggested by Ben is not suitable for you and you still want to use FSUIPC, and if you don’t mind a little (basic) coding, you could also get an Arduino board (like a Mega) and use it to interface the panel with the Link2FS software, which (if i remember well) allows you to set FSUIPC offsets based on values sent to the PC from Arduino through serial communication.

      Regards,
      David

Leave a Reply to Dávid Cancel reply