ECAM Control Panel Pinouts

L1020201

Pinouts for button and LED light control connect to a low or high speed ARINC 429 transmitter board (only two wires to the ARINC board required). Alternatively pinouts for the push buttons can be connected to a joystick board. Upper and Lower Display Unit brightness knobs should be connnected to a a potentiometer.

L1020202

The ECP, wired directly to a Cockpit Concept Low Speed Bus ARINC 429 board

ECAM Control Panel Pinouts

Canon plug B 

Input Bus 1 (The DMC1 Controls illumination of the ECP Lights): G, H
Input Bus 2 (The DMC2 Controls Illumination of the ECP Lights): K, L
Output Bus 2 (The ECP triggers the change of system pages): E, F
Power: S (28 VDC), A (GND DC)
Bright CTL Upper DU: B (WIPER), C (LO), U (HI)

Cockpit Concept ARINC 429 (LS Transceiver):
Pin G to OUT A
Pin H to OUT B
Pin K to OUT A
Pin L to OUT B
Pin E to IN A
Pin F to IN B

Connect to ground
COND: Y
DOOR: Z
WHEEL: a<
F/CTL: b<
FUEL: c<
PRESS: d<

Canon plug A

Ground: A (connect to shared ground in Canon plug A, and to the ground ARINC 429 card)
Integral Lighting (5 VDC): X, W
Bright CTL Lower: DU B (WIPER), C (LO), U (HI)

Connect to ground
EMEC CANC: Y
CLR CPT-F/O: Z
ALL: a<
RCL: b<
SYS: c<
TO CONFIG: d<
ENG: e<
BLEED: f<
APU: g<
HYD: h<
ELEC: j<

 

Direct wiring to the ECP (bypass ARINC 429 method).

One thought on “ECAM Control Panel Pinouts

  1. Pingback: ProsimA320 ECAM Control Panel | Soarbywire

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google+ photo

You are commenting using your Google+ account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

w

Connecting to %s