Referring to the 4th occupant ACP’s schematic in Drawing “23-51-08” in the A320 Aircraft Schematic Manual, the following pins are used for the annunciator lights:
Pin C – Light test (unconnected=inactive, grounded=active)
Pin P – ANN LT power LOW (GND)
Pin R – ANN LT power HIGH (Positive)
On a side note: The schematic also shows pin N (DC GND), pin P (ANN LT GND), and pin D (Simply marked “GND”) connected together, sharing the same ground bus.
Referring to this schematic, as well as Page “33-14-00” of the A319 Aircraft Maintenance Manual, the supply voltage for this specific panel can either be 6.3 or 4.3 volts DC (depending on the ANN LT switch position. BRT and TEST modes both use 6.3V).
These were taken out of official docs, so I really hope it’ll be helpful to you! 🙂
Hi Dávid
It’s long time ago. I’ve tested it again. But no lights go on. When the poti are out, they are lighting. But when I grounded pin C to Pin P or N no other lights go on. Where’s my fault?
Hi, I think brake and accu pressure indicators are driven by permanent magnet moving coil needles.
LikeLike
Stepping motor?
LikeLike
Hi Ben
How did you enable the light test?
LikeLike
You need to connect 5v and wire up the light test pin out to ground.
LikeLike
On which Pin I have to connect 5V and on which ground?
I have tried on Pin R and C.
LikeLike
Hi Guido,
Referring to the 4th occupant ACP’s schematic in Drawing “23-51-08” in the A320 Aircraft Schematic Manual, the following pins are used for the annunciator lights:
Pin C – Light test (unconnected=inactive, grounded=active)
Pin P – ANN LT power LOW (GND)
Pin R – ANN LT power HIGH (Positive)
On a side note: The schematic also shows pin N (DC GND), pin P (ANN LT GND), and pin D (Simply marked “GND”) connected together, sharing the same ground bus.
Referring to this schematic, as well as Page “33-14-00” of the A319 Aircraft Maintenance Manual, the supply voltage for this specific panel can either be 6.3 or 4.3 volts DC (depending on the ANN LT switch position. BRT and TEST modes both use 6.3V).
These were taken out of official docs, so I really hope it’ll be helpful to you! 🙂
Kind regards,
Dávid
LikeLike
Hi Dávid
It’s long time ago. I’ve tested it again. But no lights go on. When the poti are out, they are lighting. But when I grounded pin C to Pin P or N no other lights go on. Where’s my fault?
Regards
Guido
LikeLike